Diamond Systems Tritan Provozní pokyny stáhnout pdf (Strana 57)

autocast universal

230 Casting System Operation of the autocast universal Stand 21.7.04 B 17

Start-Up

• Open the argon cylinder and the cylinder pressure regulator

at the stop valve (K)

• Set the secondary argon pressure (I) to 5 bars at the cylinder

pressure control (J)

• Connect the unit to the power supply

• Turn the unit on at the main switch (D).

A signal will sound to let you know the unit is ready.

• Open the chamber door (C).

The terms are explained on

page B34 and B35.

Positioning the crucible in the crucible

holder

• Select the crucible for titanium (pure copper crucible) –

or for the selected alloy (combination crucible) support,

ceramic crucible and crucible electrode.

When casting with alloys, a ceramic crucible

(Order No. 090-161-00) is inserted into the copper crucible

support (Order No. 090-160-00).

A special crucible electrode (Order No. 090-162-00) is

attached to the crucible support with a wrench.

The rounded point should protrude slightly from the

ceramic pan.

Attention:

Use one ceramic crucible and

one crucible electrode for each

separate alloy.

Do not immerse ceramic crucible

in cold water to cool off.

• Place the clean and dry crucible (F) with the sprue facing

forward, horizontally on the bars of the crucible holder.

• Push the crucible (F) to the back of the melting chamber until

its corner support fits into the grooves of the bars, and the

nose of the crucible clicks audibly into the crucible holder (G).

For premature removal of

the crucible please push the

CAST button.

Instructions for the

autocast universal

230

Casting Unit

Pure copper crucible

Crucible holder, ceramic crucible and crucible electrode

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 89 90

Komentáře k této Příručce

Žádné komentáře

Diamond Systems Tritan Provozní pokyny Strana 57

Komentáře k této Příručce

Související produkty a manuály pro Elektrické skříně Diamond Systems Tritan