Diamond Systems Tritan Provozní pokyny stáhnout pdf (Strana 69)

autocast universal

230 Casting System Error signals – causes and remedies Stand 1.9. 03 B 29

Error signals –

causes and remedies

If an error occurs during operation or during the

process, it is displayed on the touch panel and a buzzer

is heard at intervals of one sec. When the error has

been corrected, the signal must be acknowledged by

touching Quit.

The following problems may occur:

Signal Cause Effect Remedy

Check door / lift Started with door open Process start Flip toggle

Started with casting mould not prevented. switch to upper

clamped (toggle switch not No value in position, close door

up) service mode

No quantity selected Started without selecting melt Process start Select melt quantity

quantity (fig. 2) prevented.

No value in service

mode

No arc current Plasma source does not generate Process aborted. Place material in

current despite inverter being No value in service crucible

switched on mode Check electrode

●

No material in crucible Inverter check

●

Defective electrode only by approved

●

Defective inverter electrician!

Chamber Temperature in casting chamber No effect on current Switch unit off and

temperature too high process, new process allow to cool

start prevented

Ring defective, Pressure increase in casting . Pressure monitoring Replace ring.

STOP! chamber during melting process system detects Check seal.

due to defective ring continuous excessive

pressure (min. 3 sec.)

in melting chamber.

Melting process

aborted. Cool off.

No tilting of crucible.

No value in service

mode.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 89 90

Žádné komentáře

Diamond Systems Tritan Provozní pokyny Strana 69